Thingiverse
Mega Man Buster Lamp
door arvic3d
40
Downloads
47
Likes
1
Makes
Mega Man Buster designed around the Ikea Hemma lamp kit (https://www.ikea.com/us/en/catalog/products/70312324/).
First, the lamp base screws into the bottom half, then you can screw in the lightbulb, and finally place the top half on and plug in!
This one was printed with eSun PETG, but next time I would probably just print with translucent PLA.
You don't need to worry about heat melting the print because the bulb is LED and doesn't give off much heat.
Features:
* Slot in the rear to let the cable out and sit flat
* Internal mount for the bulb in the bottom print
* Really awesome if printed with translucent filament
First, the lamp base screws into the bottom half, then you can screw in the lightbulb, and finally place the top half on and plug in!
This one was printed with eSun PETG, but next time I would probably just print with translucent PLA.
You don't need to worry about heat melting the print because the bulb is LED and doesn't give off much heat.
Features:
* Slot in the rear to let the cable out and sit flat
* Internal mount for the bulb in the bottom print
* Really awesome if printed with translucent filament
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
