Thingiverse
Megatron (Siege) Cannon
por J-zizzle
1
Descargas
2
Likes
0
Makes
I have a War for Cybertron Siege Megatron (WFC-S12). I was just having a little fun and decided to replace ol' Meg's cannon.
Basically just a slight redesign. I made the handle peg for the cannon separately. I find it adds strength that way. So, some superglue will be needed. It's just a bit larger than the stock cannon. Not too much. About the same circumference, but about 25% longer. (Now with 25% more blastin'!) Stock cannon is about 3 3/4" long. This cannon is 5" long. It's not so long that it drags on the ground. Mostly hollow, too, so it doesn't weigh down Meg's arm.
I print in PETG, slowly. It has some fine details, so you might want to crank the layer height down to 0.08.
Basically just a slight redesign. I made the handle peg for the cannon separately. I find it adds strength that way. So, some superglue will be needed. It's just a bit larger than the stock cannon. Not too much. About the same circumference, but about 25% longer. (Now with 25% more blastin'!) Stock cannon is about 3 3/4" long. This cannon is 5" long. It's not so long that it drags on the ground. Mostly hollow, too, so it doesn't weigh down Meg's arm.
I print in PETG, slowly. It has some fine details, so you might want to crank the layer height down to 0.08.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
