Meiho Powerbait tower

I have redesigned my powerbait tower to increase the strength of the clip and make it easier to glue to the tower also by extending the base under the clip it now sits well against the case when clipped in I found it best to print the tower and clip separately as it increases the strength of the clip by printing it on its side.I use superglue or epoxy glue to attach the clip to the tower. I tried a couple of different ways to print this as one but because the layers the clip if printed in any other orientation becomes very weak My printer settings:Layer height 0.2mmFirst layer height 0.2mmWalls 3-5Infill: 15-25% Cubic or GyroidMaterial: PLA+ or PETG recommended