Thingiverse
Melltorp table riser foot
door JupiterThunderbolt
21
Downloads
13
Likes
1
Makes
I wanted to put my dog crate under my table but the table was too short, so I made this! The foot raises the Ikea Melltorp table by 1/2 inch, and provides an additional inch of stable support.
I printed this at 75% infil to make it nice and solid, and a medium resolution to speed the print up a bit. I was more concerned with it being solid than smooth, so these settings were a good trade off. Feel free to mod it to fit your needs. And, obviously, print a set of four :)
I printed this at 75% infil to make it nice and solid, and a medium resolution to speed the print up a bit. I was more concerned with it being solid than smooth, so these settings were a good trade off. Feel free to mod it to fit your needs. And, obviously, print a set of four :)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
