Mendel with increased printing height

Mendel Angle project

I started this project because I wanted to increase the printing height of my Mendel Legacy printer

I wanted to change as little parts as possible, that's why I increased the angle of the down corners of the side triangles
I did not change the Z motor mounds

In this new set up it is neccessary to change the 4 down vertexes and the two top vertexes
Because of the tilting of the two threaded rods the Y motor mount which is fixed on this rods has to be changed as well

Futher ther are 4 longer threaded rods required.

Starting point where the scad files from Josef Pra
// [email protected]
// prusadjs.cz
// http://www.reprap.org/wiki/Prusa_Mendel
// http://github.com/prusajr/PrusaMendel
which are available from the RepRapPro organisation

With file mendel_angel_project.scad I wanted to see the effect of a change in angle and increase in height
In this scad file you can change the angle and the height increase
I supplied 2 STL files