Thingiverse
MendelMax 1.5+ Drawer
von DAlphaOne
11
Downloads
4
Likes
0
Makes
I made this little tool holder that fits in the bottom front left of the printer. It mounts on the inside and the drawer slides in. The knob and the drawer itself go together with the standard nut and bolt that you used for assembly. the first time i printed this, it was off by a few mm so i adjusted the files and uploaded them so they should be good in terms of size. i did not reprint mine i just cut a bit off the top so i didnt test it but i am sure it correct! if you need anything along with these files let me know
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
