Thingiverse
MendelMax Power Supply Mounting Brackets
von DR2D
47
Downloads
39
Likes
0
Makes
I needed power supply mounting brackets for a MendleMax 3D printer.
The 12 volt power supply for my MendleMax 3D printer is 113mm wide with two sets of 4mm taped holes (top and bottom) on one side and one set of 4mm taped holes (at the bottom) on the other side. The 3D printer frame width is 260mm on the inside where a 5mm screw can fasten to the aluminum extrusion inserts.
The 12 volt power supply for my MendleMax 3D printer is 113mm wide with two sets of 4mm taped holes (top and bottom) on one side and one set of 4mm taped holes (at the bottom) on the other side. The 3D printer frame width is 260mm on the inside where a 5mm screw can fasten to the aluminum extrusion inserts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
