MakerWorld
3D Printer Accessories
Go to Model
Mesh Bed Clip
129
Downloads
61
Likes
82
Makes
I designed this clip after trying to print on mesh (tulle). I found that using magnets to hold the mesh in place either severely shrank the usable area of the bed, at best, or the magnets stuck to the print head if it got too close, ruining the print at worst. This clip is low profile and holds the mesh along the edges of the bed with just enough pressure to allow proper tensioning of the fabric, and giving you use of the full plate. The clip will not interfere with the print head or screen on the A1. Like and boost if you found this useful.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
