Meshtastic Heltec Tracker LoRa Board - Enclosure with 18650 Battery Support

Printed on a Bambu P1S with Standard or Optimal print profile. I have only tried PLA for this build so far. Please note that the tolerances are pretty tight to ensure a good fitment.Flash the Meshtastic Firmware to your board, install the case and your choice of 18650 and enjoy!Parts Required1 X Heltec Tracker (915MHz for USA and Canada)1 X Switch (Optional, but there is a cutout for it)1 X 18650 Battery Holder8 X M1.7*6 Screws (I just had these laying around, others may fit)Wire (You can use what comes with the Tracker and Battery Holder)Soldering Iron/Solder/FluxHot Glue (I added a drop to the four corners of the board, the switch, and the battery holder)WiringThe wiring is pretty simple, just connect one of the battery leads to the switch, then the corresponding lead to the connector that co