Thingiverse
Meshtastic Heltec V3 (18650)
von Ham_Engineer
3
Downloads
3
Likes
0
Makes
A case for a mesh (Heltec V3 board). 18650 battery, EC11 encoder, computer speaker and KCD11 switch. The speaker can be fixed with hot glue, and I also advise you to fix the board with a drop of hot glue at the top, where the antenna is, after installation. Connection Encoder
Contact A - Heltec 5
Contact B - Heltec 6
Contact GND - Heltec GND
Encoder Button
Contact Button - Heltec 7
Contact GND - Heltec GND
Speaker + - Heltec 45
Speaker - - Heltec GND
Contacts can be reassigned in the phone application.
The PETG material was printed with minimal blowout (20%), with supports so that the holes did not have to be modified.
Contact A - Heltec 5
Contact B - Heltec 6
Contact GND - Heltec GND
Encoder Button
Contact Button - Heltec 7
Contact GND - Heltec GND
Speaker + - Heltec 45
Speaker - - Heltec GND
Contacts can be reassigned in the phone application.
The PETG material was printed with minimal blowout (20%), with supports so that the holes did not have to be modified.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
