Meshtastic Heltec V3 Mast Case

Pole mount your Heltec V3 Meshtastic radio in the weather proof case. Mounts on 3/4in sch 40 PVC pipe which protects any wires coming from your control/power box.

this case is designed to be used with the short omni antennas (~40mm rubber duckie) on a u.fl connector lead. The spring in the wire as well as the board keep the antenna in the top of the case. A spot of silicone cured with the assembly upside down would do the same. DM for longer antenna modifications or remix them if you have solidworks (files saved in SW2022).

Because of the height, these were printed on a raft. There are a few overhang features but they are all near the bottom. See image 5 and 6 for minimum support locations. full supports would extend all the way up the antenna part of the case and are not required. 25mm support limit would have you covered.

A note on the USB cable retainer. This part (shown in orange in the section view, image 8) keeps the unit from getting unplugged from any accidental pul