Meshtastic Heltec v4 enclosure block

I built a Meshtastic node for mounting outside. These models provide a good base for mounting and routing wires inside the enclosure.
The models are the main mounting block and a two-piece enclosure to hold the Heltec v4, which gets glued to the main block so it can be printed separately.


The purchased components were the Heltec v4, this enclosure: Zulkit IP65 Waterproof ABS... https://www.amazon.com/dp/B08KY7VK8W and a 18650 battery holder: DORHEA 18650 Battery Case Holder... https://www.amazon.com/dp/B098SS2596
There is a small proto board and additional waterproof cable gland, but the parts above are the main parts that the prints rely on.