Meshtastic Raspberry Pi Zero 2 based node with GPS

Meshtastic stationary node:Raspberry Pi Zero 2 (soldered longer gold pins - 17mm; regular are too short)Waveshare SX1262 LoRaWAN Node Module Expansion Board ( https://www.waveshare.com/sx1262-lorawan-hat.htm )Waveshare 1.44" LCD hat ( https://www.waveshare.com/1.44inch-lcd-hat.htm )GPS antenna (like from https://s.click.aliexpress.com/e/_DCeU5lh )UFL – SMA female connector ( https://s.click.aliexpress.com/e/_DlYPJT9 )Sirio SO 868-915-2 W/Cable antenna ( https://www.sirioantenne.it/en/products/uhf/so-868-915-2 )Printed from PETG, no supports. Print 8x between-boards-pin.GPS antenna mounted with double sided tape.Fusion source file is available. raspberry pi /boot/firmware/config.txt:dtparam=spi=ondtoverlay=spi0-0csenable_uart=1 Config pieces (config.yaml):Lora: Module: sx1262 # Waveshare SX126X XXXM DIO2_AS_RF_SWITCH: true CS: 21 IRQ: 16 Busy: 20 Reset: 18GPIO: User: 5GPS: SerialPath: /dev/ttyS0Display:### Waveshare 1.44inch LCD HAT Panel: ST7735S CS: 8 #Chip Select DC: 25 # Data/Co