Messy Dog dish shield

Our dog was creating a mess every time she ate, by pushing the kibble around with her nose and spilling it all over the floor. I was getting tired of picking it up so I made this. Works perfectly! This is designed to fit a metal dog dish with an 8.5" outer diameter rim. I'd recommend printing it in PETG because it is more flexible than PLA. The shield needs to be flexed outwards to snap into place around the rim. PLA is more brittle and might break. There will be a lot of small supports around the slot at the bottom, which will need to be removed. Takes a little time, but not too bad.