Meta Quest 3 Knuckle Strap

My design for knuckle straps for Meta Quest 3 Controllers.

This design replaces the battery cover with an arm to hold the strap away from the controller body.

Battery covers are printed in PLA and the strap and clips are printed in TPU.

When post processing the battery cover, test it for correct fit. You will most likely need to file the inside of the latch catch to get it to engage and lock the cover in place. File it down slowly and a little at a time to get the proper fit.

Thanks Chri for the scans of the Quest 3 controller used to create these models.
https://www.thingiverse.com/thing:6275072

UPDATE 11/12/2023
I have modified the models based on input by Toldwin.

I have included both left and right models now. There is less post filing needed after printing with these models. The lock pin will still need some filing but only as necessary to lock the cover in place smoothly and to allow the cover to eject when the release button is pressed.

UPDATE 11/21/2023
This model w