Thingiverse
Metal Detector Coil
par shkerin
18
Téléchargements
35
Likes
0
Makes
Simple coil base for metal detector.
Diameter 200mm, it is Anet A8 limitation, not too much, but can be customized if you have something more than I do.
Printed out of PLA
20%
0.4 nozzle
Supports are required for upper edge of the coil.
Printing time - about 9hours.
I'd prefer to make hinges a bit stronger, probably 8mm of width should be enough, but I will not reprint it :)
Just keep in mind to modify scad file if you are going to make one.
Diameter 200mm, it is Anet A8 limitation, not too much, but can be customized if you have something more than I do.
Printed out of PLA
20%
0.4 nozzle
Supports are required for upper edge of the coil.
Printing time - about 9hours.
I'd prefer to make hinges a bit stronger, probably 8mm of width should be enough, but I will not reprint it :)
Just keep in mind to modify scad file if you are going to make one.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
