Thingiverse
Metric Nut-Driver Holder
door mikesshopworks
24
Downloads
11
Likes
0
Makes
Holder for the DYN DYN2806 Dynamite 5 pc Metric Nut Driver Assortment you can get on Amazon.
I found a few different versions but they were too big and bulky or didn't look like they would hold the drivers straight. I wanted something pretty solid that could sit on a desk, in a toolbox or hang on a wall.
Holders are tapered for a snug fit so you can use this on a desk or mounted to a wall. The 3 smaller sizes fit from the top-down or clip-in.
The slots are a friction fit so these are held very well.
There are two versions. One with a back-plate and one just the holder that you'll need to drill holes-in to mount.
Back is a little thicker than required but I like the weight of it.
Can be printed flat as the overhang is not that bad on the cones.
I found a few different versions but they were too big and bulky or didn't look like they would hold the drivers straight. I wanted something pretty solid that could sit on a desk, in a toolbox or hang on a wall.
Holders are tapered for a snug fit so you can use this on a desk or mounted to a wall. The 3 smaller sizes fit from the top-down or clip-in.
The slots are a friction fit so these are held very well.
There are two versions. One with a back-plate and one just the holder that you'll need to drill holes-in to mount.
Back is a little thicker than required but I like the weight of it.
Can be printed flat as the overhang is not that bad on the cones.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
