Thingiverse
MF01 Squonk mod
by CalNatt
90
Downloads
89
Likes
1
Makes
Naked squonker, just 39x24x72mm, one piece, 18650 battery.
Best printed in nylon 100 μm, sls process.
What do you need:
-510 squonk connector 22mm, m10 thread (best with 1mm thick washer)
-piece of copper 0.5mm thick, approx 34x80mm
What do you have to do:
-cut two (or three, optional) pieces of copper according to contacts image
-drill a 10mm hole into the negative strip
-put both negative and positive strips into the mod along with the 510 connector
-put a battery, a bottle, screw an atomizer
-you're done, vape and enjoy
This is a fully mechanical mod, so be aware!
Don't go too low with your own build
Cheers
Best printed in nylon 100 μm, sls process.
What do you need:
-510 squonk connector 22mm, m10 thread (best with 1mm thick washer)
-piece of copper 0.5mm thick, approx 34x80mm
What do you have to do:
-cut two (or three, optional) pieces of copper according to contacts image
-drill a 10mm hole into the negative strip
-put both negative and positive strips into the mod along with the 510 connector
-put a battery, a bottle, screw an atomizer
-you're done, vape and enjoy
This is a fully mechanical mod, so be aware!
Don't go too low with your own build
Cheers
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
