Thingiverse
MFJ-941E tuner light, knobs and gauge bracket
door _Dave
7
Downloads
9
Likes
0
Makes
If you have a MFJ941e you may want this print. My shack is fairly dark and I never can see the settings on the tuner. I used self adhesive LED strip lights, gluing the strip under the lip. Supplied power with 12v radio power.
Black is a nice color for this but it will work with nearly any filament I used PLA, .3mm ht, 2 wall thicknesses and 20% infill print settings.
6/9/22
The switches for antenna selection and inductor setting were could be easier to use if the knob had a handle on it. Printed new knobs that operate much smoother. They fit a 1/4" shaft and use a 3mm or 440 setscrew, would be useful for many projects
Found that the gauge was loose and the clip that holds it in was broken. Printed a stronger replacement.
I also have a similar light bar for the mfj-949D https://www.thingiverse.com/thing:4352678
Black is a nice color for this but it will work with nearly any filament I used PLA, .3mm ht, 2 wall thicknesses and 20% infill print settings.
6/9/22
The switches for antenna selection and inductor setting were could be easier to use if the knob had a handle on it. Printed new knobs that operate much smoother. They fit a 1/4" shaft and use a 3mm or 440 setscrew, would be useful for many projects
Found that the gauge was loose and the clip that holds it in was broken. Printed a stronger replacement.
I also have a similar light bar for the mfj-949D https://www.thingiverse.com/thing:4352678
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
