MG MGF Lock Button Bezel

This is the Lock Button Bezel for an MG F/TF (and perhaps also fits some other MG's).
My MGF was missing one and the other one was damaged and kept falling out when going over bumps. I went through a few versions to make sure the bezel kept in place and matches the original as close as possible.

The part was printed on an SLA printer as it's relatively small and I wasn't satisfied with the results on an FDM printer. It would need quite a bit of post processing to make it look as good like the original one, that is if it doesn't break during the proces. The detail of the SLA printer made in look incredibly good from the get-go. With a few layers of paint it looks like a factory part.

The first image shows three different parts. The one on the left is what was left of my original part. The one in the middle is the part printed on the SLA resin printer and the one on the right was printed on the FDM printer. Both of the prints have not recieved post processing yet.
The second and