MG4 Car boot hook

Revised 21/04/24
Hook version 2 now has a hole to fit the headrest instead of a cut out notch. This is to add strength as the notch was the weakest point and eventually it snapped. Also upped number of walls when printed from 4 to 8.

Hole diameter is 16mm so could be used on other cars.

To fit, tilt rear seat forward, then press clip on headrest to slide out headrest. Insert hook through headrest metal bar, and install headrest. Carefully return rear seat to upright position ensuring hook does not foul rear parcel shelf.

Designed not to foul shelf when opening boot/trunk.

Created these hooks from nmurray48's car head-rest hook. These have been altered to specifically fit the MG MG4/Mulan EV. These clip to the rear seat and provide additional hooks in the boot/trunk of the car. See picture.

Print in PETG for strength/durability. Use minimum 8 walls, infill doesn't matter. Can be printed with supports, but recommend a brim. Print on it's side.

NOTE: These are