Thingiverse
MG90S Simple pan/tilt
by iira
3
Downloads
6
Likes
0
Makes
Still a WIP, model is very basic and has weak spots to improve on. I couldn't find a simple pan/tilt for the MG90S servos I had lying around, so made this as a quick POC to slap onto my Mini Talon.
The servos themselves don't seem too bad, they are cheap generic MG90S from AliExpress. With this model, they offer approx ~180 degrees of pan, ~90 degrees of downwards tilt, and ~45 degrees upwards.
Print all parts at 100% infill. I will improve the strength and fitment of things once I've flown with it a bit more, and I'm currently looking for better/alternative servos anyway, so the dimensions might need to change.
Order of assembly is important. Make sure your servos are centered before starting to avoid having to remove stuff and redo it.
- Attach the pan servo to your base of choice, followed by the pan bracket with servo horns already attached. Install shims between the pan servo and bracket as needed to remove any wobble. Make sure it doesn't bind.
- Be careful of the
The servos themselves don't seem too bad, they are cheap generic MG90S from AliExpress. With this model, they offer approx ~180 degrees of pan, ~90 degrees of downwards tilt, and ~45 degrees upwards.
Print all parts at 100% infill. I will improve the strength and fitment of things once I've flown with it a bit more, and I'm currently looking for better/alternative servos anyway, so the dimensions might need to change.
Order of assembly is important. Make sure your servos are centered before starting to avoid having to remove stuff and redo it.
- Attach the pan servo to your base of choice, followed by the pan bracket with servo horns already attached. Install shims between the pan servo and bracket as needed to remove any wobble. Make sure it doesn't bind.
- Be careful of the
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
