Thingiverse
MGB Switch Blanking Plates
16
Downloads
8
Likes
0
Makes
Plates to fit into unused rectangular switch holes in the MGB center console. Designed for and test fitted on a 1973 car. There are three options included:
- Blank plate to fill the hole (replacement for factory part)
- Blank plate but with a recessed MG logo
- RAM mount, including a 1" ball on a face plate and a backing plate for stability. There is a hole that should accommodate a 1/4" screw.
Since this part is designed to be used in a car interior, DO NOT print with PLA... it will melt. Suggested filament is PETG or better.
- Blank plate to fill the hole (replacement for factory part)
- Blank plate but with a recessed MG logo
- RAM mount, including a 1" ball on a face plate and a backing plate for stability. There is a hole that should accommodate a 1/4" screw.
Since this part is designed to be used in a car interior, DO NOT print with PLA... it will melt. Suggested filament is PETG or better.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
