MGN12H for Predator

MGN12H for Predator

necessary material:

3x 800mm MGN12H

to attach the adapter to the linear guide carriage:
12x M3x25mm
12x 15mm spacers
12x M3 washers (optional)

to fix the rod holder on the adapter:
3x 2 nuts M4
original M4 screws

to fix the linear guide to the upright:

TOT M3x20mm (in picture M3x25)
TOT M3 nuts (self-locking nuts in the picture)

3x 2 meters of GT2 6mm (optional. reinforced type, in the picture)

drill with 3.25mm bit


procedure
- remove the uprights (pay attention to the motor wiring cable)
- remove the motor plate and bottom plate
- mount the adapter on the trolley and make sure it is at the same distance from the upright as the original plate (photo 1)
- remove the original carriage and remove the support for the rods
- mount the rod support on the adapter
- position the linear guide using the appropriate spacers (4 pieces recommended). as a reference take the holes - motor side - on the upright (photo2)

- drill the uprigh