Thingiverse
Miata armrest delete
door Shawn_C
1
Downloads
0
Likes
0
Makes
If you print this in PETG it will warp.
Covers to mount where the door armrests go on a NA Miata.
I am printing these right now. I will post more photos once they are done and installed.
The two parts are slightly different. The difference in where the mounting hole is. I split it because of the size of my printer.
I added the ridge for strength to reduce warping. Total they are roughly 1/4 inch (6.4mm) thick. I am printing them with matte black petg. Should hold up ok. If not,I have black abs or cf nylon. The matte black works nice to match black interior parts.
Removing the armrest makes a surprising difference in room.
Covers to mount where the door armrests go on a NA Miata.
I am printing these right now. I will post more photos once they are done and installed.
The two parts are slightly different. The difference in where the mounting hole is. I split it because of the size of my printer.
I added the ridge for strength to reduce warping. Total they are roughly 1/4 inch (6.4mm) thick. I am printing them with matte black petg. Should hold up ok. If not,I have black abs or cf nylon. The matte black works nice to match black interior parts.
Removing the armrest makes a surprising difference in room.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
