Miata Visor GoPro Mount Angled

This is my take on the Miata Sun Visor GoPro mount. I downloaded Miata GoPro mounts off Thingiverse before, but some were not angled causing the video to be on an angle. Another design was angled but broke easily and the GoPro mount was spaced incorrectly.
I believe that this design has corrected all these issues that I've had with other designs.

You may need to widen the hole for the screw with a drill bit.

Make sure you do not use PLA because it will melt and disform in a hot car. Use PETG, ABS or similar.

You can use pretty much any nut that will thread to the GoPro screw, just heat it with a torch and smoosh it into the bolt pattern on the mount. Do at your own risk.