MakerWorld
Electronics
Go to Model
mic stand remix
70
Downloads
36
Likes
33
Makes
Just another remix of STLsuppliers 100% 3d printed microphone stand. All I did was flatten the screws on either side so they'd be stonger and not slip or break like in the original. Im sure like a rubber washer could help as well but i havent tried. The holder piece has an inner diameter of 44mm and holds up a 200g mic better than before. Thanks for checking it out!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
