MakerWorld
Coin & Badges
Go to Model
Mickey Pin Backing
83
Downloads
47
Likes
67
Makes
This is a dimensionally-accurate replica of the classic Mickey pin backing. An alternate version was already on here, but I found it to be extremely fragile, REALLY tight, and I broke the ears off of that design instantly trying to rip it off. I discovered that trading pins in the Disney park, I've lost many backings or simply just needed more. A pack of pin backings is much more expensive than you'd think, so I designed these. They are almost 1:1 in size to the originals, and the hole is accurate to the original pin backing (but I found that PLA typically has a tighter fit than the rubber backs). Hope you enjoy :). Any comments or suggested updates to the design would be appreciated :) If you like the print, don't forget to boost it! It helps me a lot! Thank you!!Boost Me
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
