Thingiverse
Micro 85 Propeller Guard
por earlynerd
28
Descargas
21
Likes
0
Makes
Simple lightweight propeller guard for the Micro 85. Weighs around 3g printed in PETG, haven't tested it too much but so far has protected the props fairly well in crashes around my home and office! I would recommend ABS, PETG, or nylon for this, PLA may be too brittle. More of an add-on than a remix, but I wanted it to be tied to t4b_'s awesome micro brushed quadcopter frame. Should fit snugly around the tops of the motors, will likely need to be scaled slightly depending on material and machine. For me, 101% fits well in PETG and 103% is about right in ABS, but your mileage may vary.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
