Micro C-130 Hercules RC model

EDIT - 15.03.2020:

Added new wing parts that can be printed completely with vase mode for better print quality and easier printing with LW-PLA. Also added Aileron02 and Elevator02 which print in one piece for vase mode, and need to be separated after printing.

------

Wingspan: 610 mm
Length: 433 mm
AUW: 100-115 g
CG: ~20mm from the leading edge of the wing center section.

For experienced users. It requires basic modeling skills to set up the control surfaces and build the plane. I have not flown the plane under power yet, but I have flown it freeflight with ballast and AUW 109 g. It flies well.

-------------------

Print settings:

Mine were all printed on normal printers witnh normal PLA and 0,4 mm nozzles. You can print thinner than 0,4 mm perimeters just fine with a 0,4 mm nozzle.

Print most parts with one 0,25 mm perimeter and 0,12 mm layer height. Use two bottom layers and four top layers for most parts. Add top layers as necessary to fill the top.

Prin