Thingiverse
Micro Drone Frame with Canopy
by zzzNeRvT
6
Downloads
5
Likes
0
Makes
Hello,
with this two remixed Things i create my own Micro FPV Race/Freestyle Copter. Flys on 2S Lipo very well and its very lightwight. Print the Frame in PLA with 100 Infill and holes for a Lipostrap. For the Moment its strong enough and for the Canopy i use Resin.
Frame with holes for Motors is for Motors with 3 pin Connector. No solder needed.
For this Copter i use.
-BetaFPV 12A AIO Board 1-2S with ELRS Onboard
-Eachine Nano VTX (25-400Mw)
-Schubkraft 12000 KV Motor with 3 Pin Connector 1-3S
-2 blade Props 65mm with 1mm Hole
-Runcam Nano 2
-Tattu R-Line 550 mah 2S Lipo or Tattu 450mah 2S Lipo
with this two remixed Things i create my own Micro FPV Race/Freestyle Copter. Flys on 2S Lipo very well and its very lightwight. Print the Frame in PLA with 100 Infill and holes for a Lipostrap. For the Moment its strong enough and for the Canopy i use Resin.
Frame with holes for Motors is for Motors with 3 pin Connector. No solder needed.
For this Copter i use.
-BetaFPV 12A AIO Board 1-2S with ELRS Onboard
-Eachine Nano VTX (25-400Mw)
-Schubkraft 12000 KV Motor with 3 Pin Connector 1-3S
-2 blade Props 65mm with 1mm Hole
-Runcam Nano 2
-Tattu R-Line 550 mah 2S Lipo or Tattu 450mah 2S Lipo
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!