Thingiverse
Micro Popper
por AAEM
0
Descargas
1
Likes
0
Makes
Length is about 1.8"
Volume is 6.75g/cm3
You'll have to use smaller wire as the tie on. I would use the .020" diameter wire if you have it.
I've included a one piece and a two pieces (two halves). For the one piece, if you want to add a BB, add a pause in order to add a BB. The weight of the BB will be determine by the slicer's setting (Wall count, and infill %).
Note: it's a topwater popper so your total weight should be well below 6.75 grams. It's a micro popper.
Recommended setting: 2 walls & 5% infill will get you 4grams.
My YouTube Shorts video: https://youtube.com/shorts/m6pJC8dfk3g?feature=share
Volume is 6.75g/cm3
You'll have to use smaller wire as the tie on. I would use the .020" diameter wire if you have it.
I've included a one piece and a two pieces (two halves). For the one piece, if you want to add a BB, add a pause in order to add a BB. The weight of the BB will be determine by the slicer's setting (Wall count, and infill %).
Note: it's a topwater popper so your total weight should be well below 6.75 grams. It's a micro popper.
Recommended setting: 2 walls & 5% infill will get you 4grams.
My YouTube Shorts video: https://youtube.com/shorts/m6pJC8dfk3g?feature=share
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
