Thingiverse
Micro SD Card Box
por davidkerton
12
Descargas
4
Likes
0
Makes
I printed the original and found that the SD cards don't sit further in the case as the pictures showed., as a result, the lid ended up snapping an SD card when screwed on.
As a result, I remixed the lit to increase the height between the SD card and the lid and also added a centre ring so that the lid screws onto that keeping a good height with the SD card.
20% infill
Supports not needed
V3 Lid added - Internal ring resized to match ring on bottom half of box.
As a result, I remixed the lit to increase the height between the SD card and the lid and also added a centre ring so that the lid screws onto that keeping a good height with the SD card.
20% infill
Supports not needed
V3 Lid added - Internal ring resized to match ring on bottom half of box.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
