Thingiverse
Micro SD card holder for MP Select Mini v2
von biohzrdmx
1
Downloads
2
Likes
0
Makes
Bought a Micro SD card extender from AliExpress (as the one in the MPSM is kinda fragile) and the other designs were not what I was looking for, so I made my own.
Printed with Hatchbox PLA, it requires the following hardware:
- Two M3 L6 screws
- Two M3 L3 OD5 brass hot insert nuts
Mounts using the existing screws, just unfasten them one at a time, present the holder and fasten again, then repeat.
You will need one of each piece (1x base + 1x cover), no supports or rafts are required.
Once printed just apply the brass inserts with a soldering iron on minimum heat.
The only issue is routing the ribbon cable for the extender, currently I only ran it from below the printer body, but I'm pretty sure a more elegant solution exists.
Printed with Hatchbox PLA, it requires the following hardware:
- Two M3 L6 screws
- Two M3 L3 OD5 brass hot insert nuts
Mounts using the existing screws, just unfasten them one at a time, present the holder and fasten again, then repeat.
You will need one of each piece (1x base + 1x cover), no supports or rafts are required.
Once printed just apply the brass inserts with a soldering iron on minimum heat.
The only issue is routing the ribbon cable for the extender, currently I only ran it from below the printer body, but I'm pretty sure a more elegant solution exists.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
