Micro Swiss NG Accelerometer/Sonic Pad G-Sensor Mount

I found that the STL's Creality provided for mounting the accelerometer packaged with their Creality Sonic Pad would not work with a Micro Swiss NG so created one. With very little area on the NG for a mount to work, I chose to utilize the screw holes for the bottom of the hotend fan. To mount, remove the existing bottom two screws on the hotend fan. Attach the mount with two M3 x 16 screws.This is intended to only be attached as long as it takes for the accelerometer to be used, then should be removed before doing any prints so that it doesn't obstruct air flow.