Thingiverse
Electronics
Go to Model
Micro USB Housing
56
Downloads
46
Likes
0
Makes
Similar to GlassCurtin's https://www.thingiverse.com/thing:3026077
Am tapping into a 3D Printers' power supply to step down its power to 5V for a Raspberry Pi and wanting to make a power cable using a MicroUSB Male Type B 5-Pin Jack Port Solder Connector that will fit in a tight space, I needed to design a housing.
Since left and right housing pieces are mirror's of each other, I included both.
Will need to flip over Part B before printing.
Used 0.2mm layer height
Placed connector with wires into housing halves and glued together. Used a vice to hold 2 housing halves together while glue cured.
Am tapping into a 3D Printers' power supply to step down its power to 5V for a Raspberry Pi and wanting to make a power cable using a MicroUSB Male Type B 5-Pin Jack Port Solder Connector that will fit in a tight space, I needed to design a housing.
Since left and right housing pieces are mirror's of each other, I included both.
Will need to flip over Part B before printing.
Used 0.2mm layer height
Placed connector with wires into housing halves and glued together. Used a vice to hold 2 housing halves together while glue cured.
Scotty-G also publishes on
38 additional models across 2 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
