Thingiverse
MicroDyze
von SurgeFF
1
Downloads
2
Likes
0
Makes
OH!
You will have to play with how you mount everything, you may need to turn somethings around, may need to swap out a heater block for a slimmer one. Ive used a V6 style clone block from some cheap Chinese manufacturer. Had to make sure the block was sticking out the back instead of the front.
So found out by accident that with a tweak the DyzEnd X part cooling file I had found will fit and work tremendously especially when remote cooled. 25mm will work just the same as a 4010 radial blower, just barely enough but if your clever you can get some really good prints. Be careful with printing this one. Its tough but can be done.
You will have to play with how you mount everything, you may need to turn somethings around, may need to swap out a heater block for a slimmer one. Ive used a V6 style clone block from some cheap Chinese manufacturer. Had to make sure the block was sticking out the back instead of the front.
So found out by accident that with a tweak the DyzEnd X part cooling file I had found will fit and work tremendously especially when remote cooled. 25mm will work just the same as a 4010 radial blower, just barely enough but if your clever you can get some really good prints. Be careful with printing this one. Its tough but can be done.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
