Thingiverse
Learning
Go to Model
Microfuge 8 Place Rotor
87
Downloads
99
Likes
3
Makes
A centrifuge is EXTREMELY DANGEROUS, do not use these files to make one. These files should only be used for information purposes.
I am too cheap to buy a microfuge so I designed this rotor to attach to my RC motor. The mounting hole is .25" diameter and was designed to fit an exceed-rc rocket series 86MA08 brushless motor. The tube angle is 55deg and the rotor holds eight 1.5ml microtubes. This part was designed in Geometric Design (formally Alibre Design). The original file can be altered to accept larger or smaller shaft sizes.
Revision 1: Changed angle to 55deg
I am too cheap to buy a microfuge so I designed this rotor to attach to my RC motor. The mounting hole is .25" diameter and was designed to fit an exceed-rc rocket series 86MA08 brushless motor. The tube angle is 55deg and the rotor holds eight 1.5ml microtubes. This part was designed in Geometric Design (formally Alibre Design). The original file can be altered to accept larger or smaller shaft sizes.
Revision 1: Changed angle to 55deg
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
