Thingiverse
Microgreen seed tray
von Oneill_2l
1
Downloads
5
Likes
0
Makes
Hello,
I needed two years to make it perfect. A Microgreen Tray for the small consum.
It included a saucer, the Tray and a lid for Blackout. Put the tray in the saucer, fill it with Substrate and distribute the seeds.
Spray it with water -> two days with weight on the Lid -> two days Blackout an then put it under a light.
If you don't know how you can do it: There is a instruction: https://www.youtube.com/watch?v=U8FLrcvkTBM
PLA is enough for indoor.
If you want to wash it in the Dishwasher you need PETG or heat resistance Materials.
Have Fun and enjoy your Microgreens.
This was a lot of work for me. I am not a Designer. XD
I would appreciate a little Tip. Thanks!
created by Oneill_2l
I needed two years to make it perfect. A Microgreen Tray for the small consum.
It included a saucer, the Tray and a lid for Blackout. Put the tray in the saucer, fill it with Substrate and distribute the seeds.
Spray it with water -> two days with weight on the Lid -> two days Blackout an then put it under a light.
If you don't know how you can do it: There is a instruction: https://www.youtube.com/watch?v=U8FLrcvkTBM
PLA is enough for indoor.
If you want to wash it in the Dishwasher you need PETG or heat resistance Materials.
Have Fun and enjoy your Microgreens.
This was a lot of work for me. I am not a Designer. XD
I would appreciate a little Tip. Thanks!
created by Oneill_2l
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
