Thingiverse
MicroMag Cram'N'Jam Feed
door PeculiarDesigns
34
Downloads
26
Likes
0
Makes
Cram N Jam style feed designed to fit PTP MicroMag, not certain if this will fit all generations.
Requires two o-rings to retain your 10 round tube, just size some rings that that will snugly hold your tube in place.
**Be careful with the retaining screw/screws! Make sure they don't stick too far into the breech where they can collide with the bolt.**
Requires two o-rings to retain your 10 round tube, just size some rings that that will snugly hold your tube in place.
**Be careful with the retaining screw/screws! Make sure they don't stick too far into the breech where they can collide with the bolt.**
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!