Thingiverse
MicroMagic Main Boom Assembly
di vash_mishka
5
Download
6
Likes
1
Makes
By my coworker and MicroMagic enthusiast i was asked to print a main-boom assembly...
It is a work in progress kind of thing ...
I printed 104% to compensate for shrinkage, instead of the 103% i mentioned before.
I made a few small changes to the design to make it all better fit.
It's printed on 0,10 density with 50% filling on fast mode (not sure if the 50% will matter as parts are already that small)
Also the boom part (giek) Is printed standing as a cylinder... First few tries were done laying down as shown but results were not 100% what we liked so to make the parts with little to no post printing work. I decided it was better to change the print position. Also I printed them in pair of 4 to 5 to give the material time to settle.
All is done on a standard Da Vinci 1.0a with 2.0 firmware and parts are drawn in FreeCAD V0,15
It is a work in progress kind of thing ...
I printed 104% to compensate for shrinkage, instead of the 103% i mentioned before.
I made a few small changes to the design to make it all better fit.
It's printed on 0,10 density with 50% filling on fast mode (not sure if the 50% will matter as parts are already that small)
Also the boom part (giek) Is printed standing as a cylinder... First few tries were done laying down as shown but results were not 100% what we liked so to make the parts with little to no post printing work. I decided it was better to change the print position. Also I printed them in pair of 4 to 5 to give the material time to settle.
All is done on a standard Da Vinci 1.0a with 2.0 firmware and parts are drawn in FreeCAD V0,15
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
