Thingiverse
Micrometer stand, monoblock
by pattarini
6
Downloads
4
Likes
0
Makes
Micrometer stand 3.0
Loose derivative of the nice design of Wehrenseb
It is a single piece + the knob
Prints without supports from the side. There is also thefile for a knob for M4 hex ("Nipplo")
You will need one screw with hex head, about 50mm long, and one hex nut, M4.
It can be fastened to a heavier base again with M4 screws, or you can put rubber foots.
Uploaded 3 models for the jaw, for different thickness of the micrometer: 7mm (for bare metal manual micrometers), 11 and 15mm for those with plastic sides.
also two sizes of the base. See the name of the file for the size.
Was designed for Xibei /QLR micrometers and has their logo on it.
May improve the design in case of positive/negative feedbacks
Loose derivative of the nice design of Wehrenseb
It is a single piece + the knob
Prints without supports from the side. There is also thefile for a knob for M4 hex ("Nipplo")
You will need one screw with hex head, about 50mm long, and one hex nut, M4.
It can be fastened to a heavier base again with M4 screws, or you can put rubber foots.
Uploaded 3 models for the jaw, for different thickness of the micrometer: 7mm (for bare metal manual micrometers), 11 and 15mm for those with plastic sides.
also two sizes of the base. See the name of the file for the size.
Was designed for Xibei /QLR micrometers and has their logo on it.
May improve the design in case of positive/negative feedbacks
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
