Thingiverse
Microphone boom arm table bushing
di rtarb
0
Download
0
Likes
0
Makes
Needed a table bushing for an OC White boom arm, found out they charge $72 each for them, so I made my own.
This will also work for any boom arm that has a 13mm peg on the end. This also works for my Warm Audio WA-MBA arm.
Supports are needed for the bushing. I printed mine with the flat side down. Getting the support material out of the hole can tricky but is possible.
This will also work for any boom arm that has a 13mm peg on the end. This also works for my Warm Audio WA-MBA arm.
Supports are needed for the bushing. I printed mine with the flat side down. Getting the support material out of the hole can tricky but is possible.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
