Thingiverse
Microphone Stand Connector
door ChaosCoreTech
50
Downloads
41
Likes
0
Makes
Hey! Check out this video to see why and how I made this: https://youtu.be/crpTvGrWdM4
So I'm sure not a lot of people have a need for this, but someone might, so I posted it anyway. This is the part that allows the mic stand to attach to the arm that holds the microphone (or camera in my case). I designed it to be pretty much exactly like the original that broke. But the original was metal and this is plastic, so this part is very fragile and probably shouldn't be used for a real solution. But it is holding. I've been using it for about a week now and I've been careful, so it hasn't broken. This was more of a test to see if I could tap a print myself. And it worked! Success. :)
I printed this at .3mm layer height, PLA, and no supports. It took a little over a half an hour to print.
So I'm sure not a lot of people have a need for this, but someone might, so I posted it anyway. This is the part that allows the mic stand to attach to the arm that holds the microphone (or camera in my case). I designed it to be pretty much exactly like the original that broke. But the original was metal and this is plastic, so this part is very fragile and probably shouldn't be used for a real solution. But it is holding. I've been using it for about a week now and I've been careful, so it hasn't broken. This was more of a test to see if I could tap a print myself. And it worked! Success. :)
I printed this at .3mm layer height, PLA, and no supports. It took a little over a half an hour to print.
ChaosCoreTech publiceert ook op
2 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
