Thingiverse
Microscope slide Antfarm
von Ameisen_Park
6
Downloads
7
Likes
0
Makes
The nest is for small ants only because the tubing is 9mm in the outer diameter
DON'T use supports on the nest with a glass floor because the slide is meant to be put into the model mid printing!
After printing just slide some steel mesh into the forseen Gap, put some cotton into the watering chamber and slide the slide in place.
the tolerances are at 0.3mm to get the modules to slide together
DON'T use supports on the nest with a glass floor because the slide is meant to be put into the model mid printing!
After printing just slide some steel mesh into the forseen Gap, put some cotton into the watering chamber and slide the slide in place.
the tolerances are at 0.3mm to get the modules to slide together
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
