Thingiverse
Microscope slide holder leaf spring
von Johnrandersen
1
Downloads
0
Likes
0
Makes
This is for a microscope with a bed thickness of 17.5 mm
The ring part goes into the round part of the finger. Then in snaps on to the small clips on the bed attachment piece.
The finger needs to be bent with heat or boiling water to bend down with as much force as you would like.
The ring part goes into the round part of the finger. Then in snaps on to the small clips on the bed attachment piece.
The finger needs to be bent with heat or boiling water to bend down with as much force as you would like.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
