Microscope Slide Preparation Holder

This holds standard 75mm x 25mm microscope slides for you while you are preparing them.SizingMeasure your slides, they may not be exactly the size they claim to be! There's a little bit of tolerance in the model (76.2mm x 25.2mm), but you can scale this up slightly if you need. It is designed to hold a slide securely while having minimal contact with the side itself. Eight large studs hold the slide in position, stopping it moving sideways, Four smaller studs raise the slide up from the base plate of the holder, All these are near the ends of the slide, as far away from the central area as possible.Apart from these studs, the slide does not touch anything. A positioning grid is shown at the centre. This is a square of size 18 - 22mm (to match typical square cover slips), with a central ‘crosshairs’ design. PrintingYou can print this in one color, or change color after the base plate is printed to give better contrast for the positioning grid. This can be printed in PLA, PETG, or AS