Thingiverse
Microswiss Fan Shroud Light Version!
von JeenyusPete
25
Downloads
12
Likes
0
Makes
noticed the design was a bit off, I've now edited it and and made it fit proper with lots of room for the silicone sock and wires etc, saves one heck of a lot of weight on the carriage, this is made for use WITHOUT a part cooling fan so mostly only good for ABS and other materials with high warp and split factors. reason for doing the swap is because the hotend cooling fan pushes alot of air out of the bottom of the stock carriage, this helps eliminate that draft which can cause warping and layer splitting along with other issues we run across.
also included are the step files i took to get to the finished product, first file is basically the fixed version of the original, the second "Edited" version is with the stronger side fins but crude edges, third "Clean" edition is the strongers fins version with some cleaner looks to the added strength parts
Print in a good heat retardant material like ABS, PETG, Polycarbonate, Etc
Print with fins standing up and add supports under the m
also included are the step files i took to get to the finished product, first file is basically the fixed version of the original, the second "Edited" version is with the stronger side fins but crude edges, third "Clean" edition is the strongers fins version with some cleaner looks to the added strength parts
Print in a good heat retardant material like ABS, PETG, Polycarbonate, Etc
Print with fins standing up and add supports under the m
JeenyusPete veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
