Slicer Discord
Midnight Sunflower – 3D printable model from MakerWorld MakerWorld
Decor

Midnight Sunflower

6 Downloads
11 Likes
1 Makes
Go to Model
MIDNIGHT SUNFLOWERThis is my latest household decor. A beautiful midnight sunflower, that almost looks like a spider.It is perfect for your leaving room, it gives a nice touch on the wall with its unique effect. For the Assembly:Is very simple to put it all together.Print all the components.Before you install it on the wall, buy a Lamp fixture (see picture 1). Ideally one that matches the fixture's hole diameter demonstrated on the assembly sheet.Install the Lamp fixture on the base, simply by pushing it through the hole, then use the fixture's threaded clip to secure it in place.Install all the fins on the base. This is very simple, but be careful as they have a curved surface, first push gently and then twist.Finally you can install the wires on the lamp fixture before you install it on the wall.Note: Lamps can get very hot. Therefore use only Led Lamps to avoid overheating the material. Lamp Fixture(Picture 1) As you can see on the picture, there is a ring above my fingers.
Category
Decor
Source
MakerWorld
Published
Updated
What you need to print this: Beginner Low confidence
Single piece
Supports 1/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 0/3
Printer
FDM / FFF
File format
STL
Material
PLA
Min. bed size
50 mm (Small)
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection