MightyOhm Geiger Counter Case

A case for the MightyOhm Geiger Counter Kit, which “fully” encloses the sides of the board. This model can be printed in any of your favorite materials (though TPU might be a bit difficult) and in any print profile. Reuses these parts from the kit's case:4 short hex standoffs4 long round standoffstop plate8 screws4 washersAdditional parts needed:18 M3 SHCS - 6-10mm lengthAssembly is straightforward:Install the 4 short hex standoffs and 4 long round standoffs to the PCB as instructed in the kit's manualPlace the printed base on the bottom of the kit using 4 of the kit's included screwsAttach the sides to the base using 10 M3 SHCSAttach the kit's clear plastic top cover using 4 of the kit's included screws and washersFinish by using 8 M3 SHCS for structural support for the sidesThis case for the MightyOhm Geiger Counter Kit is intended for educational and entertainment purposes only. This case is not intended to keep you or the MightyOhm Geiger Counter Kit safe. Use c